Myrtenaster - Weiss' Sword (Rapier) from RWBY

cults3d

Myrtenaster, Weiss Schnee's signature Rapier from RWBY. Yes, the barrel spins! "I'm Not Perfect. Not Yet, But I'm Still Leagues Better Than You." This was probably one of the more ambitious props I have modelled and assembled, it certainly took a bit more time that my previous models to get the final result. Printed at full size, the total length is 963mm with the longest printable section 280mm (see dimensional drawing). This is the blade tip, which if printed diagonally should fit fine on a 200x200mm print bed (Prints in halves rather than vertically). I have also included a version of the blade which is split into smaller parts with the longest section being 160mm if needed It's designed with a 6.5mm hole through the center allowing for a 6mm threaded rod to be inserted along the length to give it strength (glue in place). Most of the mating surfaces also have 2mm registration holes to align each part correctly, I use small offcuts of 1.75mm filament in these holes. There are 3 options for printing the barrel. 1 variant has the shells in place already as part of the barrel (Barrel_Solid_No_Bearings). The second variant is that same as this but has slots to add bearings to the barrel (Barrel_Solid_W_Bearings). The final variant has the bearing slots, but also has the barrels empty, with the shells included as a separate part (Barrel_Empty_W_Bearings). I used 606ZZ Ball Bearings 6*17*6 mm (see photo), not sure if they really helped the barrel spine much or not. I also added 2x M6 flat steel washers on either side of the barrel to help it spin, this is optional, but if you dont have washers, there is a printable spacer that will fit as well. The 4x guards that go around the barrel were a bit of a pain to print. They fell over on my print, so I added a halves version where you print 8x of the half guard and glue them together. In terms of overall assembly, I started by gluing the halves of the sword tip onto the metal rod, and then worked my way down section by section. For the Barrel, I assembled the Barrel on the threaded rod with the bearings and washers etc, and then glued 2 of the guards and the 'Guard base' part on at the same time to get the spacing correct (see photos). This was definitely the most finnicky part of the assembly, but the registration holes help. In terms of Glue, I used a 5 minute, 2 part epoxy (often called Araldite here in Aus). It gave me good strength but an easy enough working time to assembly things. If you have any questions, dont hesitate to reach out, I'd be happy to share how I assembled it all. The model with the sword in the photos is @Armada.Cosplay on IG, follow her to see more of my props in action If you make one of my designs, I'd love to see it! Please DM or Tag me on Instagram (@asgardian_armoury) or Reddit (u/Asgardian_Armoury)