Myles Garrett Christmas Ornament

thingiverse

Use your favorite lithophane settings. I did use a 30mm base to make sure the ornament didn't fall during printing on my other one this size. I hope you enjoy. Print time on my other this size with my setting took about 9 hours. I designed it to be 60mm in size. I used this for the light inside. https://www.amazon.com/dp/B08HSYJ31Z/ref=cm_sw_r_apan_glt_fabc_0HM88JCA1T9S6B1J6ZFD?_encoding=UTF8&psc=1&tag=thingiverse09-20 I wish I would have found this one when I ordered cause you get so much more for the price. I ended up ordering like 12 for $10. I took the little rubber loop off of the light and glued it to the opening to the ornament. Then after it dried I then inserted the light back into the rubber loop and into the ornament to where I still had the twist part sticking out to turn on and off. This also helps that if you ever have to change the batteries or even the whole light you can still remove the light and insert new batteries or light. I hope you enjoy.