MyKeys Multi Key - Key Holder

cults3d

This is an 8 key multi key holder that does not use any external hardware. 100% 3D printed. No support is needed if you orient all parts as shown in print preview however, support is turned on just in case. You may need to use shim washers (stl's included) to give the keys a friction fit. Not all keys have the same thickness. I had to use two dual shim washers. I also included key place holder spacers just in case you don't have a total of 8 keys that you want to hold. (Not shown in pictures.) I also included a blank top plate If you don't want the MyKeys logo on the top plate. You may need to file the insides of the clip surfaces if the fit is too tight on the pins. To use: Insert pins into bottom plate, load 4 keys on each pin on the bottom plate, place the top plate on top of the keys, then slide the clips on. If the keys seem loose and there is not a good friction fit then use some shims. *** UPDATE *** There is now a version of the bottom plate that has a loop for a key ring. It is Rev C Bottom Plate included in STL files now. This will need a bit of support. Orient so the flat side is down. *** UPDATE 7-14-2022 *** Added 3mf file format. This has not been tested but I believe mimics the stl files. I would appreciate feedback if anyone does use the 3mf files.