My simple Knob

thingiverse

Instructions Using the following settings: KnobHeight is set at 20 mm TaperPercentage is turned off ShaftLength is fixed at 15 mm HoleDepth is adjusted to 25 mm Pointer2 has been deactivated Pointer1 has reached its maximum value of 100% RingMarkings have been added in a pattern of 10 on each ring RecessOuterRadius has been set at 20 mm DRotate is fixed at 45 degrees FlatSide is locked in the position with two flat sides DivotDepth is set to zero RingWidth is zero, creating a thin appearance RecessDepth is fixed at 10 mm KnobDiameter has been set at 60 mm CapType has not been used The Knurled setting is engaged, for an interesting tactile experience. HoleDiameter has been adjusted to fit the specified size of 6.275 TimerKnob is deactivated for this model RecessInnerRadius has been adjusted to allow for more efficient recessing at a diameter of 12 mm ScrewHoleDiameter is fixed to prevent excessive thread stripping and cracking NotchedShaft, is at its highest setting with a total notch length of 80 percent of the total shaft diameter of 12.