My Kitty Lithophane Light

prusaprinters

Why does any one need a picture of my cat? I have no idea but, I made it and, it came out awesome so, here it is!If you need a little mood lighting in your print room this is the perfect way to take care of that. The panel was made to fit EScvn54's “Desktop Lithopane Frame”.Print at 100% infill with a layer rate selected for high detail and this STL will yield a near photo-quality lithopane.  Note while the case says it will fit 120 x 90 lithopanes that is a really loose fit.. This pane will print slightly larger.  About 122 x 92 for a tighter fit.After you print the case parts, assemble the bottom using 2 M3x8mm screws. There are many ways you can light this. A hole in the side allows for the pass-through of a power wire. Mine lights through this unit from Harbor Freight. It's battery powered, and the brightness level and effects are adjustable with a remote control. BONUS! It doesn't cost that much!I have begun to put together a series of lithophanes that all fit the same holder. You can swap out the picture according to your mood the season or whatever! The collection can be g found HERE.