my hero academia - kirishima fantasy au daggers

thingiverse

# Kirishima's Daggers from My Hero Academia's "Fantasy AU" These daggers were modeled based on limited official art pieces. Please note that these are designed for a 6'1'' guy and measure ~26.5'' at default size, so some resizing may be necessary. **Estimated Print Time:** ~13 hours (I suggest using a raft to ensure the seams are as flush as possible) You can find support through a hole running through all the pieces big enough to snugly fit 3/8'' dowel, which is commonly found at any old hardware store. **Warning:** Depending on your printer, the tolerance of the dowel hole can get pretty tight. If you cannot work the dowel through the longer portions of the blade, a good alternative is to cut the dowel rod into sections and stick as much as you can into each piece of the sword. If you're planning to bring this to a con, make sure to sand the tip down, as it's painfully pointy fresh off the printer.