My Customized Vase-O-Matic!!!

thingiverse

This thing is a customized version of the Thing #744385 on Thingiverse. It was created using Customizer, which can be found at this link: http://www.thingiverse.com/apps/customizer/run?thing_id=744385 To assemble or print this design: Use the options listed below to adjust the settings as desired. 1. **Smoothness**: The level of smoothness in the 3D model's surface. Adjust from a low of 0 to a high of 100. * Setting: 36 2. **Outer Radius**: The distance between the center point and the outer edge of the design. Can be set anywhere from a very small value (close to zero) up to several hundred units or more, depending on how much material is available. * Setting: 1 3. **Which Twists**: Determines which parts of the model are twisted together when creating it. Set from a low of one (the center part) up to many (many smaller pieces). * Setting: 3 4. **Floor Thickness**: The thickness of the bottom portion of each piece before twisting begins. * Setting: 5 5. **Base Shell Thickness**: Sets how thick or thin each individual twisted part will be in relation to the floor's total width after creation and print job has been done. * Setting: 4.5 6. **Iterations**: Number of time points when model starts repeating its path from initial state into different directions without halting process yet because certain limitations need exceeded before end stage achieved where printing takes place afterward too possibly causing further alterations needed later due finishing tasks properly carried forward correctly done without hassle arisen within those processes naturally allowing completion easier faster way done successfully always maintained perfectly fine condition maintaining healthy expectations met throughout entire journey till last bit reached ultimate fulfillment completely fulfilling all objectives set forth at very start indeed completely accomplished successfully now.