My Customized USB stick and SD card holder

thingiverse

Customized version of http://www.thingiverse.com/thing:46335 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=46335 Instructions Using the following options: Set Sign TYPE to one. Round up Pencil radius to four. Place three units between pencils. Choose build plate number zero for automated operation. Separate USB port by a gap of four units from the sign board's top edge. Leave two units open before SD slot. Identify the device type with value one for compatibility with the provided design settings. Pick a digital font that fits perfectly with Orbitron for optimal visibility and readability on signs like this one. Choose Connector Type as three to integrate additional functionality within your printed design elements; assign five units space between USB sticks horizontally across each sign unit's surface while ensuring there remains sufficient breathing room at bottom where they connect through ports laid out below those connectors set eight units apart from one another vertically along same length but only counting from starting edge up towards end so SD cards don't get lost easily due positioning limitations imposed by printing limitations affecting final build result achieved following provided configuration guidelines carefully considered beforehand when inputting respective values manually selecting each attribute listed within customization panel accessible via customizer link referenced initially. Assign Device Order with the value of one to maintain consistent labeling and layout throughout printed products made using this particular thing file version uploaded here specifically customized as requested prior by specifying precise parameter selections which ultimately combine harmoniously according desired user specifications accurately translating intended message effectively conveyed via designed output. Finally, insert USB Extra as zero because additional storage is not required for this specific device setup.