My Customized USB stick and SD card holder

thingiverse

This model was generated by customizing a pre-existing design from the website http://www.thingiverse.com, accessible at the following URL: http://www.thingiverse.com/thing:46335. Customization details are reflected in options chosen using the tool located here: http://www.thingiverse.com/apps/customizer/run?thing_id=46335. The instructions provided indicate a user chose settings as follows: A gap for MicroSD is five units deep. Three units separate pencil from device or case when stored within enclosure, depending on orientation of assembly pieces in relation to other elements contained in model set. Four unit diameter defines circular radius for lead (or pen). User opted to utilize this design type. User prefers use of alphabetic characters only for sign, utilizing a standard font. User selected specific USB port location by adjusting space or gap created, at a distance four units from opposite end where USB connectors enter case structure housing device or electronic device in the custom designed object set produced through creation and selection process described here. Specific information chosen was also given by user during interactive input procedure: Text displayed as digital sign is Jennifer. Type of connector chosen fits three classifications provided based on function performed and how unit interacts mechanically with outside environment in normal use mode, taking all structural components of this custom assembled thing into consideration simultaneously. Assembly steps or requirements mentioned earlier must be observed for completion; details may require modifications at some points to suit user preferences properly. Device orders dictate sequence construction pieces occur according upon building process - user selects which device will come out of printed piece first (in default configuration no specific devices were included but rather general design parameters allowing insertion at chosen time as needed). Total number assigned by setting was for one single unit device. Manual control input given for size along x axis and position within designated box during production, measuring hundred percent along both vertical lines on each side. Height determined to remain six full units when assembled completely; any additional changes need addressed through modifications at user discretion throughout execution steps. Custom sign design elements include specified type of device used in printing setup. Final details incorporated relate specifically toward how it interacts physically via specific characteristics identified by these customized parameters combined under standard model provided through unique settings applied before assembly completion stage