My Customized Ultimate Nut Knob Generator long

thingiverse

Customized version of http://www.thingiverse.com/thing:713300 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=713300 Instructions Using the following settings: Height is set to twenty-five units. Nut width is set at seven units. The design is optimized for supportless printing, with a setting of one. Knurled height has been adjusted to forty units. Knurl density has been increased to fifty percent. The nut features six sides and a thickness of four units. Screw hole length has been extended to one hundred units. Knurl strength has been enhanced to five units. Backlash has been set to a minimal value of 0.1 unit. Cross-section has been eliminated from the design. Bottom thickness has been reduced to 0.6 units. The screw hole diameter is fifty-five units. Diameter two is set at one hundred twenty-five units. Diameter one is adjusted to one hundred fifty units.