
My Customized Tree
thingiverse
Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=279864 Using the following settings: Instructions • Root ratio: 60% max • Overhangs allowed: None (default setting) • Stopping point for budding branches: 71 • Minimum branch length to root ratio: 70% • Angle tolerance for overhanging branches: 50 degrees • Twist angle for each branching node: 55 degrees • Maximum branching angle: 55 degrees • Minimum number of new branches from each existing one: Four • Tip-to-root diameter minimum ratio: 50% • Initial seed point location: Coordinates (254, x-y axis not specified) • Minimum required branching angle for splitting nodes: 40 degrees • Number of iterations allowed in generating new branching paths: Seven • Custom cross-section shape definition used: Elliptical (#6) • Main base geometry shape type: None (#0) • Specific custom shape description applied to entire branch tree model: Three points forming the trunk section ((15.32, 17.36), (47.55, 11.73), (24.79, -11.78)), three pairs of side branches with taper points on top ((29.39, -44.17) to (-0.00, -29.79) to (-29.39, -44.17), same for left and right; two main points form lower base geometry section: (9.99E-07, -29.785); remaining three sides are formed with two linear segments starting from center and crossing both inner top sections twice ((24.78, -11.77) to (-47.55, 11.73), (29.39, -44.17) to (15.32, 17.36)). • Use of advanced parameters: None • Minimum root-to-trunk ratio for each main branch stem generation point: 50% • Tip-maximum-diameter-ratio allowed at any branching position from parent trunk diameter during process phase: 70% • Buds start their new growth pattern: Beginning from distance along existing parent stem =81 Trunk length set at maximum 40 units Allow buds keep going even beyond first generation - all subsequent generated paths (nodes): yes Diameter ratio allowed before truncation is reached - in the overall branch development of individual and/or any one section segment for its entirety during initial stages till termination (100) percent Diameter at starting growth centerpoint established by given dimensions on base point or any further added shape specification in reference point data within branch tree description used during final build-up (10) units
With this file you will be able to print My Customized Tree with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on My Customized Tree.