My Customized Tree

thingiverse

This is a customized version of the object found at http://www.thingiverse.com/thing:279864, created using Customizer (http://www.thingiverse.com/apps/customizer/run?thing_id=279864). The parameters used for customization are as follows: advanced settings were not used (use_advanced_settings = 0), root maximum ratio was set to 60, a maximum of four branches can originate from each branch (max_number_of_branches_from_each_branch = 4), the minimum branching angle is 40 degrees (min_branching_angle = 40), tip minimum ratio is 50 (tip_min_ratio = 50), a basic shape was not used (base_shape = 0), and a custom shape was provided as input (custom_shape). The branch diameter cutoff is set to 1.6, maximum branching iterations are limited to five (maximum_branching_iterations = 5), the seed value for randomization is 179, tip maximum ratio is 70 (tip_max_ratio = 70), a minimum of two branches must originate from each branch (min_number_of_branches_from_each_branch = 2), the allowed overhang angle is 50 degrees (allowed_overhang_angle = 50), trunk length is set to 40 units (trunk_length = 40), branches can continue growing after reaching the stop budding position (branches_keep_growing = 1), branch twist angle is 72 degrees (branch_twist_angle = 72), stop budding position is 60 (stop_budding_position = 60), length minimum ratio is 70 (length_min_ratio = 70), root minimum ratio is 50 (root_min_ratio = 50), start budding position is 50 (start_budding_position = 50), length maximum ratio is 100 (length_max_ratio = 100), maximum branching angle is 55 degrees (max_branching_angle = 55), and the branch cross-section shape is set to type 5 (branch_cross_section_shape = 5). The trunk radius is 15 units (trunk_radius), and all overhangs are allowed except where specified otherwise (allow_all_overhangs = 0).