My Customized Tree bigXL

thingiverse

Instructions for Printing Tree Structure Model To print this tree model, follow the specified parameters. Trunk length will be set to forty units and seed size at thirty-three. The ratio of the root diameter to the trunk radius is capped at sixty, while a minimum of fifty is allowed. Choose from one type of branch cross-section shape. The maximum percentage increase in branch diameter relative to the main stem is fixed at a hundred percent, with no limit for the top part. The chosen branch and trunk diameters will be thirty units and thirty respectively. A more complex set of rules are being used as a substitute to standard tree growth models, where some settings may override or take precedence over others. For those advanced users that want it customized to their exact needs. This will have implications for both branching angle and growth limits for every branch segment created. Branch length ratios must meet requirements. When creating new branches from existing ones there should be no more than three added per stem in most cases with only the highest growing area being exempt due an adjustment needed because its not possible to create over twenty eight individual segments of wood while ensuring good tree health and a symmetrical shape that grows straight. Each additional growth cycle is dependent upon meeting minimum number of branch requirements - typically at least two on each sprouting location after first cycle when buds form - before continuing the overall development process through natural tree growing stages or until stopped manually using custom setting which defines when it should cease adding new twigs along the chosen stopping point near base level but only reaches full growth potential under normal conditions where every single node could expand naturally.