My Customized The ultimate PEG board accessory creator v1.2

thingiverse

This Project is Customized to Perfection It's Based on http://www.thingiverse.com/thing:245556 and Built with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=245556 Instructions Are Provided Below You Will Need the Following Settings: * Hole Size Must be 7 mm in Diameter * End Arm Should Make Up 50 Percent of the Overall Structure * Choose the Peg Item You Prefer from the Available Options * Backing Board is Typically Measured at 6 Inches * Add Shelf Support by Setting It to Yes * Allow for a Tolerance of 5 mm in Your Construction * Ensure the Hook Width Makes Up Exactly 104 Percent of the Overall Project Size * Place Pegs 25 Percent Off From Each Edge * Each Peg Should Be Approximately 31 Inches Long