My Customized SpeakerGen

thingiverse

Customized version of http://www.thingiverse.com/thing:451253 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=451253 Instructions Using the following settings: Driver Voice coil Vas is set at 1.132 Port Extension Offset is positioned on Port X at - portXOffset Port Position is aligned with the rear surface Terminal Hole Diameter is configured to be forty units Port Wall Thickness has been increased to five units Height of enclosure in relation to box depth is set to three-point-zero Speaker screw hole diameter set at three-and-two-fifths Vertical alignment for ports adjusted zero percent Make Port enabled off Port length set at one-hundred units Terminal configuration: dual wire holes setup Manual calculated box volume configured two Specifications will be displayed on screen enabled yes Q measurement set at point nine zero Driver sensitivity Qts has been reduced to six-eighty Spacing between terminal screw holes set to fifty percent Number of screws holding terminals to enclosure four set Total Thickness of Box ninety Diameter of speaker ports: eight-zero units Recommended Sound Pressure level measured at the speakers mouthpoint (Fs) : Seventy-Three HZ. The option has been disabled: CloseBox volume measurement no The relation of box Width Ratio configured Eight-point-seven to depth. The calculation has set Port diameter at twenty internal diameters.