My Customized Snap-Fit Blower Fan Duct ()

thingiverse

Customized version of http://www.thingiverse.com/thing:1109880 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=1109880 Instructions Using the following options: Mount thickness is set at six. Base mount diameter is twenty. Base bolt diameter is five point four. Tip distance is thirty. Base bolt height is three. Outer width is thirty. Fan bolt diameter is four point four. Notch offset is point nine one. Nut diameter is seven. Fan mount diameter is eleven. Outer length is forty. Radius is twenty-two point five. Notch clearance is half a unit. Tip length is thirty. Base bolt counterbore is ten. Separation is twenty-five. Notch from edge is one. Nut height is two. Notch length is ten point eight five. Tip width is four. Central z-coordinate is twenty-five. Central y-coordinate is twenty-five. Notch width is one point nine. Elbow inner radius is zero point oh one. Fusion of curves parameter is two hundred. Thickness is one point two. Elbow angle is ninety.