My Customized QR Code Generator for Customizer

thingiverse

Instructions Using the following settings: Quality tolerance: Set to extremely low, just 0.001 inches Tag width: Exactly eighty, a solid line of symmetry Tag thickness: Only three mils thick, barely there QR code scale: Scaled up by six-tenths of an inch for maximum readability Number of corners: Limited to just one, sharp and precise Radius of curvature: Rounding off each corner at a ten millimeter radius Case thickness: Maintaining the structural integrity at twenty-four point four mils QR code size: Custom printed at exactly forty-one by thirty-nine point six inches Data encoded on the QR code: A specific message number, precisely five characters Thickness of QR code layer: Five thousandths of an inch to create a bold image QR code positioning at the bottom: Just one millimeter off the ground, hovering above Horizontal tag height: Eighty millimeters high, straight and level QR code's horizontal coordinate: Absolutely positioned at zero X-axis value QR code's vertical coordinate: Absolutely positioned at zero Y-axis value Flip mode on or off: Currently turned off, in standard position Sub-total line enabled: The extra lines below are always present Size of the inner hole: Set to a round circle with ten millimeter diameter Vertical positioning of the inner hole: Always aligned vertically, perfectly symmetrical at zero Horizontal placement of the inner hole: Placed precisely at thirty mils distance from edge