My Customized PieceMaker - Build your own board game pieces

thingiverse

Instructions Using the following options: Resolution is set to standard, producing clear and detailed results at 32 dpi. Coin Diameter has been specified as 19.05 mm for precision workpieces. To refine details, a taper pinch of 3.5 mm is employed for optimal grip. The desired taper shape, achieved with a tool, has been determined as 1.5 mm for maximum control. To increase the structural integrity of the design, the top height has been set to an impressive 12 units. The shoulder flare has been adjusted to provide ample support at 20 degrees. To customize further, twist type 3 is selected for flexibility in use. The rim strength parameter has been adjusted to accommodate a maximum force input with value 1. Setting the number of coins has been bypassed by selecting 0 as there are none needed. The choice of stem type has been made based on usability, settled upon at setting 1. Additional design strength is applied by choosing shoulder height value 6. For customization purposes, extra rim thickness is set to an increment amount with value 0. Setting the flare top results in additional structural stability for delicate models through 15 degrees. Optimization of base structure relies on a flared diameter set at baseFlare = -15 to avoid obstructions from nearby pieces when positioned carefully along design lines. Setting of diameter, height of design component dictates an outer layer dimension measured by base flair and calculated at diameter 26. To fine tune aesthetic details top rotation is optimized through a value input at topRotation = 0 Precise measurements call for height specification set with a value 1.52 assigned to height of the coin within specified range. Final check of values indicates designNumber as established in final output of customization procedure is equal to 8 and also the precise positioning of slanted piece through the setting topSlant = 0