My Customized Phone Wall Charger

thingiverse

Instructions for Customizing Your Thing To use this design, please select from the following options: Height: I've chosen 60 units Text depth: I set it to one layer CScrewCountersinkDiameter: This will be 8 mm in size CScrewDiameter: You'll need a drill bit of 3.85 mm BaseHeight: The foundation is at 13 units tall HoleDepthModifier: Don't worry about this one, I set it to zero PhoneZ: That's the phone at 16 units from bottom PhoneX: This dimension is now set to 85 Countersink: There are three countersinks placed evenly spaced Text: This will say 'Walter's' on your creation CSlack: Allow a small slack of 0.2 units here CScrewCountersinkDepth: I set this to 10 mm deep ChargerZ: Place the charger 6.5 units from the top ChargerX: Now, it's centered at 10 units wide Font size: All text is in 7-point font CScrewHoleRight: Leave one side unscrewed - just like me! WallThickness: I chose a standard wall thickness of two units holediameter: Drill out the hole to 3 mm Slack: Give it a little extra slack - I used one point oh! OutsideBand: The outer ring will be at four units width