My Customized Pegstr - Pegboard Wizard

thingiverse

Here's your customized project: http://www.thingiverse.com/thing:537516 It was made with Customizer! Check out how it works here: http://www.thingiverse.com/apps/customizer/run?thing_id=537516 Instruction You are going to use the following options: The holder is a cube and the count on its x axis is 1. On the y axis, we've doubled up, so that makes it 2. The side size of this box in x direction is 30 mm wide while on all sides, you want your corners to have no curvature at 30 mm each corner and sides that cutouts should go as per what's defined (this case being a small amount so don't remove any cuts). Now adjust the size of y-side - it must be 12 units high (make sure there isn’t too much). You’re asked how strong do you want to make things because, obviously, they won’t fall off then - go at around three-sevenths. Also tell how close up at bottom can be placed when this part closes up by half an inch less from where it would have originally closed – if necessary so it isn't just hanging free. In all honesty there are 7 options in your thing's settings (and these all got turned on): You set what's being put inside those small cube spaces above - count for holders x-axis should be equal to how many times I need make a duplicate on this specific side while doubling counts both x & y sides but do make adjustments appropriately.