My Customized Parametric Stackable Sub-irrigating Plant Pot & Dish

thingiverse

Here are the settings for creating a custom funnel and pot stand: To assemble this customized project, follow these instructions carefully: You can adjust the following options to customize your piece: Use an outlet diameter of 5 units Set the height of the funnel to 10 units Increase the amount of dish support pieces to 6 Optimize the model for a resolution of 40 units Specify a distance between the tripod and the center of 30 units Set the diameter of the pot to 80 units Establish a distance from the dish supports to the pot's surface as 30 units Heighten each dish support to 3 units Elevate water reservoir capacity to 25 units Design the thickness of each part as 2.5 units Extend the length of each dish support piece to 10 units Specify the height of the pot as 70 units Include all components in the final assembly Exclude additional features that add complexity Elevate the height of the outlet hole by 20 units Define a smaller intake size for the funnel's spout at 5 units Expand the width of each dish support piece to 25 units Decrease the overall height of the water reservoir as 7 units Establish a diameter for the water reservoir as 60 units Create a small gap between the top and bottom of the water reservoir of 6 units Raise the overall height of the dish slightly to 15 units Reduce the diameter of the funnel's intake hole to 10 units Adjust the maximum curve of the pot as 100 units