My Customized Parametric pulley - lots of tooth profiles

thingiverse

Created by the Customizer on Thingiverse, here's what you're looking at: Using these options: • twenty teeth • pulley bearings with a height of nine units • one M3 nut with hexalateral facets • a retainer standing proud at 1.5 units tall • retainer with dimensions measured in integers (1,1) • one nuts only available, numbered sequentially as number one • five point seven for flats in the M3 nut • diameter of thirty-five for pulley bearings • nut and shaft distance measured as 1.2 units • another fifteen and a half inches high, this time an idler unit sits waiting patiently • number two to no less than (the previous) single quantity, more so (one) • increase in width due additional tooth spacing measured two hundredths • seven or eight - pulley top height now established • a straight one ninety on the angle side for M3 nuts at nine-zero degrees. The other specifications you see mentioned Profile measurements all in six Additional Tooth dimensions come in zeroes since that's what's required M3 diameter coming in short of three units as requested Motor Shaft, another 8 point 3 measured precisely.