My Customized Parametric project box for PCB electronics projects

thingiverse

Here's the Spun Version of the Text Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=841942 Instructions You will need these settings to make this thing work right: - part_selector is number 3 - the size of each cylinder is 5 units round and it sticks out 7 units from each side wall - the bottom base height needs to be set to 20 units tall - make sure to print cover on your y-axis offset by 10 units for correct fit - you need a smooth rounded edge, so the radius will be 7 units on all corners outside of the model - the thickness of the circuit board has to be at least 3 units - the outer part of the case should be around 3 units thick - space each cylinder out by about 7 units from side wall for best look and fit - add a little bit more height on your cover with a total of 5 extra units above where it touches model's edges - set this box dimension to be roughly 70 x 100 so you don't see too much of any single aspect as one whole unit and give some wiggle room at the bottom by setting that thickness up around 2. - You should round down that screw hole by taking half its value, since radius needs only the diameter to do calculation and you've probably gotten the radius in millimeters. So make it .75 units if your default unit isn't inches or don't convert the measurements on you now, let's round this down to 0.5 of an inch as I didn't have space for conversion factors or other explanations for you so use one decimal.