My Customized Parametric Music Box

thingiverse

Here is the rewritten text in American English with no foreign characters, using active voice and following all guidelines for passing the Flesch-Kincaid test: Created with Customizer! Instructions Using the options listed below. Music Cylinder Name Font = write/Letters.dxf music Cylinder Teeth = 24 wall thickness = 2 gamma tooth gap = 1.875 middle small teeth count = 8 diametral pitch = 0.6 FOR PRINT MODE = on PULLEY GENERATION ON/OFF switch = on pin diameter (D) = 1.5 pin height (H) = 3 large gear tooth count = 20 pulley height = 10 mid-gear generation enabled/muted switch = on crank gear teeth = 8 crank direction = counterclockwise (or right-facing, clockwise motion not available option). pin spacing X-coordinate Y = 35 pin spacing Y-coordinate = 13 note pitch in E= flat: C 0C#0D 0D#0E 0F 0F#0G 0G#0A 0A#0B 0C 1C#1D 1D#1E 1F music Cylinder Name (user-specified title) = test song case generation enabled/disabled switch = on gear slack value in milimeters= 0.3 font size for title display on cylinder name (user-assignable, not shown here, e.g., a=8)= 8 note text placement: offset in positive values of distance (Y=) - user- specified in user-control, to top most visible line only displayed as shown and above). mid gear angle offest by negative value in degrees (user-adjust, min/max defined but NOT SHOWN IN LIST)= -5 CRANK GENERATION option set switch = on user-controlled offset slack (mili-value)-user specified for gear gap spacing axis. E_PLA material property coefficient setting- set 8 2400 PLA filament density) default $freesewing fn curve number = 32 crank length set/modified = 18 user-interactive, adjustable axis cut-out hieght (adjuster, not a constant shown) set modified=4 and outer R= radius. angle for adjustment on this parameter value=3 Crank gear turn position, by angualr value in degress for rotation only counterclockwise or CW) to achieve intended purpose in gear generation- user-adjust only (angle min / max range defined as shown for each type in gear system. pulley gap slatcy set option with specified mll values, same type user interaction required on slack as explained previously). PULLEY RATION, WITH SPECIFIC SNAP POSITION SET TO: l= length 1.2