My Customized Parametric Music Box

thingiverse

Here are the generated instructions to print the custom model: Using the following settings: Gear Teeth Count: 8 Minimum Gap between Gears: 0.1 units Crank Base Frequency: 16.3516 Hz Crank Gear Angle: -15 degrees Mid Gear Angle: 5 degrees Rotating Layer Thickness: 924 microns Gap between Pulleys: 1 unit Pulleys per Pin Y Axis: 35 Pulleys per Pin X Axis: 13 Teeth Per Tooth Note Ratio: 1.875 units Debug Mode for Gears: Disabled Music Cylinder Name Position: Centered Music Cylinder Depth: 0.6 units Crank Axis Cut Away Height: 4 units Rough Diameter of Pulleys: 3 units Snap Gap at End of Pulleys: 1.2 units Minimum Diameter of Gear Teeth: 1.5 units Number of Alpha Notes: 5 Flag for Printing Gears and Music Cylinder: Enabled Mid Section Teeth Count: 20 Allowance in Crank Length for Slack: 0.2 units Height of Music Axis Holder: 3.4 units Generate Customized Music Cylinders: Enabled Tolerance for Gear Tooth Alignment: 0.1 units Depth of Mid Section Gears: 3.3 units Pitch Diameters of Gear Teeth: 0.6 units Holder Depth from Top Edge: 4 units Maximum Allowance between Gear Teeth and Housing Walls: 10 microns Customizable Options: Enter Custom Parameters to Change Printed Model