My Customized Parametric Hole Grommet & Snap-in Flush Cover V3

thingiverse

Customized version of http://www.thingiverse.com/thing:1030514 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=1030514 **Instructions** Using the following options: - Adjust the cover catch offset to 0.8. - Chamfer the flange at a 45-degree angle. - Use screws with a pitch of 4 units. - Set thread height to pitch ratio at 50 percent. - Make the flange width equal to 25 units. - Calculate fillet dimensions for 100 percent of total area. - Add a hole in the cover, 90 percent of total size. - Set panel thickness at 13 units. - Create holes with diameters measuring 100 units. - Increase the flange thickness by an additional 4 units. - Improve model resolution to 90. - Include grommet measurements at 4 units thick. - Extend plug length to 100 percent of available space. - Decrease cover hole diameter to 90 units. - Make the cover wall as thin as 3 units possible. - Determine edge type by rounding corners with fillets. - Keep a gap-free, flush-style cover finish throughout.