My Customized Parametric Herringbone Gear Se1st att.t for Stepper Extruders

thingiverse

Customized version of http://www.thingiverse.com/thing:6544 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=6544 Instructions Using the following settings: Gear2_bolt_sink is set at 15. Gear1_shaft_d is 5.25 units deep. Gear2_shaft_outer_d measures 65. The gear1_captive_nut_h dimension is 3 units tall. The gear1_captive_nut_d diameter is 6.2. Gear2_bolt_hex_d measures 15 in hex size. The gear2_setscrew_d setscrew has no width. AT stands at 0.02 precision. Gear1_setscrew_d is 3.5. Gear2_teeth counts as 79 points. Gear2_shaft_d reads as 8.5 diameter. Gear2_cut_circles count is five full turns. Gear1_teeth score a 19 out of twenty marks. The bridge_helper_h height registers as three tall units. The gear2_captive_nut_h has no captive height set. The gear2_captive_nut_d shows a blank diameter value. Gear_h measures 15 total length with the unit dimension in full height setting active now at gear_shaft_h which is fifteen, and the other two gear_shaft_offset values gear1_setscrew_offset equals five units. Set up your options: distance_between_axels stands as sixteen zero and gear2_rim_margin set for one thousand six hundred zero margin free. generate stands blank and set on.