My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Customized Version of Bolt - Thing #193647 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=193647 Options Used: • thread_step: Set to 1 thread per turn • head_type: Standard socket type • inner_diameter: Exactly 6mm in size • nut_resolution: Resolution of the nut thread is set at 0.5 steps • drive_type: Uses a standard slot drive system • nut_thread_outer_diameter: Outer diameter of the threaded area is set to 9mm • nut_thread_step: The pitch or angle between threads is adjusted to 2 steps per turn • thickness: Wall thickness is kept constant at 1mm • thread_outer_diameter: Thread outer diameter matches exactly with 6mm • head_diameter: The head's outermost edge has a diameter of precisely 12mm • wing_ratio: Wing ratio (for bolts) was adjusted to a setting of 1 • countersink: Counterbore depth is increased to facilitate a 2mm setting • head_height: Head height is raised above the plane with an added height of exactly 5mm • non_thread_diameter: Diameter in the untapped section remained unchanged at 0 mm. • nut_type: A standard, traditional threaded bolt type was used • thread_length: Total length of thread is measured to be precisely 8 turns deep. • slot_width: Standard slot width used for ease and flexibility • drive_diameter: Drive diameter or the part around which this thing turns, has a precise measurement of exactly 5mm • nut_step_shape_degrees: Angle of threaded turns adjusted upwards to approximately 45 degrees from straight thread • step_shape_degrees: Entire structure shape modified so that outer turn faces inwards at the exact same angle, roughly estimated to be around 45 degree deviation • facets: Total of six smooth curves and/or points make up the face pattern. • type: This thing's category clearly identified as "bolt" • nut_diameter: Overall size for this fastening is large at 12mm • non_thread_length: Threadless part, i.e., the cylindrical shaft measured at around ten turns. Length to which we want our structure exposed on either side • texture: Texturing and engraving not applicable or allowed; therefore left unchanged at 'exclude'. • outer_diameter: Maximum visible portion (the cylinder without heads), is made roughly equivalent to fifteen in terms of size unit, with that one size unit equal to 1mm. • nut_height: Overall measurement height including a socketed nut tip equals six.