My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Customized version of https://www.thingiverse.com/thing:193647 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=193647 Instructions Using the following settings: Nut Thread Step 4 is not recommended, using default setting Nut Thread Step to be 2. The preferred drive type for nut_thread_step = 2 and normal will be socket instead. The standard drive diameter for a hex head_diameter should be no more than 5, with our selection being 6. Facets count selected was set as 6, not required for regular drive_type types, unless additional specifications need extra surface accuracy checks. Our main drive characteristics remain as selected including Slot width chosen as 1. As usual drive diameter remains constant to our socket requirement @ 5. Selected head orientation specified is hex based. Set the shape of steps to degree of angle by using 45 instead for nut_step_shape_degrees or set it back up if desired Chose correct material outer thread dimensions - at default recommended setting size nut_thread_outer_diameter 9 will suffice and remain at a normal configuration drive. Nut diameter set was picked correctly as we determined it should be equal to, and in the form of '12'. The slot Depth specified in our model selected remains 2. We set up all relevant features. We have used setting '1' for "Wing" (wing_ratio). It will counter-sink using 4 - at setting "countersink:2" if it doesn't exist; this would apply extra cuts or the hole, or both and that won't hurt since no texture exists. It may still need more if required or possible with the chosen nut_height which equals six Finally set thread length to equal twenty five at a non_thread_length = "0" setting, in effect disabling further cuts as needed (to add) as requested in this selection, also we must choose and configure drive_diameter size that matches the specifications @ 8 Selected dimensions and details: nut resolution selected remains as default recommended size for best visual detail output @ "0.5", to provide desired print quality with accurate modeling - non_thread_length chosen equals zero and remain set at our current specifications Set standard values - Inner_diameter must match specified @ 9 (our previously established specification size in diameter was indeed a "d" measurement Inner_Diameter @ 9 also represents thread_inner_diameter as established and determined - so all other details can stand. Outer-Diameter remains, outer thread set constant to equal fourteen Our current specifications include, for all users of 3D printer's setting for nut D is correct (or right in size) when specified at 12 and not changed here with settings such that our non_thread_outer_diameter also does this remain correct and will hold true for most - although we see it doesn't add a non_threaded region but can use our current specification - selected values should then hold up to required accuracy as standard outputting. Thickness must be equal and so selected (remains) is indeed @ 2