My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Here are the specifications used to create this item on Thingiverse: Item created with the Customizer application available on Thingiverse. Created at http://www.thingiverse.com/apps/customizer/run?thing_id=193647. The instructions below assume you have chosen these settings for this bolt: Head Height: 4 mm Wing Ratio: 1:2 (1 unit wing to body) Nut and Screw Details: Diameter of Bolt: 14 mm Bolt length: 25 mm Non threaded portion length: 0 Outer diameter including nut thread is the total thickness with a bolt head. Diameter of Non-Threading Portion is the bolt diameter Diameter for drive screw: (1 unit smaller than head):5.0 Inner Diameter of Bolt Head, Inner: 8 mm Length through non threaded area before start threading again, step size is at (45 degrees) Height and Type for bolt thread count in metric measurements of inner core. Screw Type for Drive screw for driving head: Phillis Type Number of Facets on outer layer, which gives appearance as to how rounded a nut/screw would be Outer Thread Count Size for Screw Drive in Diameter measurements Depth measurement at which a hole or cut would go into a bolt head is equal in this setting to thickness =2 The width and number for cutting slits, that are present for screw heads with wings to grab onto. Type for Bolts is 'Normal' Length for threading for normal bolthead screw type, measured in millimeters. Length to count or add as thread (outer diameter 14-9) the length after the main body ends of thread. Drive bolt's width (threaded outer diameter =7) Width between two screw grooves (threads), at a constant angle:45.