My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Customized version of http://www.thingiverse.com/thing:193647 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Instructions Using the following settings: Socket facets are set at 6. The head type is hexagonal in shape. The thread step is set at 2. The slot depth is exactly 2 units deep. The step shape degrees are set to 45. This design features a nut as its primary component. The outer diameter of the nut thread is precisely 9 units wide. The head diameter measures out to 12 units across. The socket depth reaches down to 3.5 units in depth. Normal nuts are used in this design. The drive type is designated as a socket. The outer diameter of the entire object is 14 units around. Thickness is maintained at a consistent 2 units everywhere. Nut diameter measures out to 12 units across. Slot width is precisely 1 unit wide. Resolution is set to an impressive 0.5 units per step. Drive diameter measures out to 5 units in size. Normal nuts are utilized in this design. Facets are set to 6 for added detail. Inner diameter measures out to 8 units inside. Countersinks are applied at a depth of exactly 2 units. Non-threaded diameter is left untouched at 0 units. Nut thread step is set to the same value as previously mentioned. Wing ratio remains unchanged at 1 unit wide. Nut height reaches up to an impressive 6 units tall. Head height measures out to 5 units above base level. Thread length extends a considerable 25 units in length. Thread outer diameter is precisely 8 units across.