My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Customized version of http://www.thingiverse.com/thing:193647 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Using the following options: nut_diameter is set at 12mm. nut_thread_outer_diameter is 9mm. the nut has a faceted shape with six facets. each facet of the nut has a resolution of 0.5 units. threading on the nut happens in two millimeter increments. type of item being created: washer diameter for the drive bolt or screw: 5mm drive type is socket height of the nut is set to 6mm angle of nut steps: 45 degrees. type of nut being made: standard or normal. texturing on this item has been turned off or excluded. the diameter of the head of this item is also 12mm. countersink for head or top surface is 2 units. step increment in threading is two millimeters. length of thread section on item: twenty-five millimeter. outer diameter of item is 8mm when threaded section is removed. height of the head section is five millimeters. no diameter assigned to non-threaded part, meaning it may not exist at all. wing ratio on this object is one-to-one. length of area without threads is set to zero. item thickness overall: two units or two millimeter. shape of the head or top surface: hexagonal. outermost diameter or measurement: fifty millimeter. width of slots cut into object, if applicable: 1mm inner or hole diameter is thirteen millimeter in this object. step shape angle on some objects: 45 degrees again here and as previously mentioned.