My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Instructions Using the following settings: Slot width: Set to 1 Thread length: Adjusted to 25 mm Step shape degrees: Rotated by 45 degrees Nut step shape degrees: Also set at 45 degrees Socket depth: Measured at 3.5 mm Head height: Increased to 5 units Resolution: Set at 0.5 units Thickness: Maintained at 2 units Drive type: Selected as socket Facets: Configured for 6 facets Head type: Chosen as hex Thread outer diameter: Established at 8 mm Non-thread length: Kept at 0 units Type: Designated as nut Nut type: Standard issue Socket facets: Also set to 6 facets Nut thread step: Reduced by 0.5 mm Thread step: Set to 2 mm Non-thread diameter: Held at 0 mm Texture: Excluded from design Nut thread outer diameter: Measured at 9 mm Countersink: Increased by 2 units Head diameter: Set to 12 mm Nut height: Elevated to 15 units Nut diameter: Maintained at 12 mm Outer diameter: Established at 14 mm Drive diameter: Set at 5 mm Slot depth: Measured at 2 mm Wing ratio: Held constant at 1 unit Inner diameter: Maintained at 8 mm