My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Customized version of http://www.thingiverse.com/thing:193647 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Instructions Using the following options: Type is set to nut. Inner diameter specified as eight millimeters. Resolution is 0.5 millimeters. Slot depth determined at two millimeters. Nut height fixed at six millimeters. Non-threaded diameter set to zero millimeters. Step shape degrees established at forty-five degrees. Slot width narrowed down to one millimeter. Facets count upped to six units. Nut diameter enlarged to ten millimeters. Socket depth calibrated at three and a half millimeters. Non-threaded length fixed at zero millimeters. Drive diameter defined as five millimeters. Nut type selected as normal type. Head diameter measured at twelve millimeters. Drive type set as socket drive. Head type chosen as hex head. Thread step widthened to two millimeters. Thread length extended to twenty-five millimeters. Nut thread step size set to two millimeters. Outer nut thread diameter established at six millimeters. Head height established at five millimeters. Socket facets count upped to six units. Countersink value adjusted to two millimeters. Texture excluded from the design specifications. Outer diameter enlarged to fourteen millimeters. Wing ratio fixed at one unit. Nut step shape degrees set identical with forty-five degrees. Thread outer diameter specified as eight millimeters. Thickness measured at two millimeters.