My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Customized version of http://www.thingiverse.com/thing:193647 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=193647 Instructions Using the following settings: nut_resolution is set to 0.5 nut_diameter measures in at 12 6 facets make up the shape of this thing nut_thread_outer_diameter is precisely 9 the thread_step is exactly 2 units this is a bolt type part, not any other kind drive_diameter checks out at 5 units long head_diameter matches the specification with 8 units long the nut_height reaches as high as 6 drive_type requires a socket in this build nut_step_shape_degrees forms an angle of 45 degrees sharp it's the normal kind, nothing more or less, just nut type countersink stands at 2 to perfectly fit into anything we're excluding texture on this thing, for some reason it isn't needed here. the next key setting is that nut_thread_step exactly equals 2 as required by this project file build this thread length to precisely match 30, and be exact on that length always this part was specifically designed for an outer diameter size of 4 threads all over that outside space non_thread_diameter was built right into design and should not go past those set specs of inner 0 and no change is needed to these figures so lets stick with it at that level then, set this wing ratio equal exactly one, you can be exact with this thing as per file demands add 5 to the height value then let this all set and make changes later as part moves from file state the final slot_depth goes for an impressive but standard amount of depth – namely a full number, two at its most outer width it matches the specified design value exactly of that given setting number 1.