My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory.25-20

thingiverse

Using the following options: * drive_type is set to socket * thickness is adjusted to 2 millimeters * resolution is set at 0.5 * nut_height is specified as 6 * countersink is applied with a depth of 2 * facets are defined as 6 flat surfaces * head_type is chosen as hexagonal * non_thread_length remains unadjusted, currently set to 0 millimeters * inner_diameter is set to 8 millimeters * nut_diameter is specified as 11.11 millimeters * slot_depth is adjusted to 2 millimeters * nut_resolution is matched at 0.5 * wing_ratio remains consistent at 1 to 1 ratio * thread_step is fixed at 2 steps per turn * non_thread_diameter is unadjusted, set to 0 millimeters * drive_diameter is maintained at 5 millimeters * thread_length extends 25 millimeters from the base * head_diameter is established as 12 millimeters * type of feature is chosen as a nut * texture is excluded, leaving smooth finish only * nut_type selected as wingnut style * nut_thread_step measured in 1.27 turns per centimeter * slot_width defined at 1 millimeter * head_height specified at 5 millimeters * step_shape_degrees is optimized for sharp edges, set to 45 degrees * outer_diameter is established as 14 millimeters * nut_step_shape_degrees are defined at a moderate angle of 60 degrees * nut_thread_outer_diameter maintained at 7.35 millimeters * thread_outer_diameter extends out to 8 millimeters