My Customized nut holder for t-slot

thingiverse

Created with Customizer at http://www.thingiverse.com/apps/customizer/run?thing_id=353938 Instructions Using the following settings: - nuts arranged horizontally on Y-axis = 10 - nuts aligned in a line across X-axis = 5 - screw radius is set to 2.0 - width of slots cut for bolts = 11.5 millimeters - thickness of washers installed below heads = 0 millimeters - depth of nuts where screw holes are drilled = 3 millimeters - middle slot location is positioned 3.0 millimeters off-center - overall length including thread in nut housing = 16 millimeters - dimension of square cross-section through one flat side of nut = 7.2 millimeters - height from bolt slots to base surface of component is .8 millimeter - vertical stack up to bottom surface from top edge of bolt slot total = 3.4 millimeters - washer radius installed under heads of screw bolts = 5 millimeters - each nut on this housing unit is positioned without rotation.