My Customized NOMOON Speaker Generator

thingiverse

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=590871 Instructions Using the following settings: port Internal Diameter is set to 20 mm terminal Notch Rotation is adjusted to 180 degrees clockwise wire Hole 2 Angle is calibrated at 270 degrees counterclockwise wire Hole 1 Angle is set to 0 degrees speaker Hole Diameter is set to 77 mm speaker Screw Hole Spacing is configured for 58.2 mm center to center port Length is established at 70 mm speaker Mount Countersink depth is increased by 8.5 mm from standard setting manual Sphere Internal Diameter is adjusted manually to 130 mm terminal Notch Oval Width is expanded to 24.5 mm speaker Screw Hole Diameter remains constant at 3.25 mm wire Hole 1 Diameter remains unchanged at 2.5 mm making Bass Port option is enabled by default sphere Wall Thickness is increased to 5 mm from standard port Wall Thickness remains set at 8 mm terminal Notch Inset value remains steady at 2.2 mm flat Bottom Of Print Diameter If No Bass Port remains constant at 20 mm speaker Mount Diameter stays at 93 mm wire Hole 2 Diameter keeps its original setting of 2.5 mm hole Angle adjusts to an optimal setting of 52 degrees option use Manual Sphere Internal Diameter is switched to true number of Speaker Screw Holes set to 4 in a standard pattern terminal Notch Oval Height adjusts upward by 20 mm trench Depth adds 2 extra units from the minimum make Terminal Notch option remains switched off by default sphere Volume Liters remains constant at 1.5 L marking Thickness is established at a depth of 0.5 mm