My Customized mounting bracket modules for shelving system

thingiverse

This project was created on thingiverse.com, with a customizer that can be accessed at www.thingiverse.com/apps/customizer/run?thing_id=725453. Instructions: 1. Ground offset should be set to 16. 2. Edges should have a fillet radius of 7 units. 3. Back parts amount must equal 1. 4. The foot width needs to measure exactly 30 units. 5. Board holes should be precisely 3 in size. 6. Shell thickness has to be at least 2 units thick. 7. Connectors count must reach a total of 2 pieces. 8. Holes for board and braces need to exist, respectively. 9. The bottom part is set as not being it, due to specific design choices. 10. Back parts holes also measure 3 in size exactly. 11. Notches extend exactly 35 units lengthwise along the surface. 12. Connector angle is precisely fixed at a 90-degree angle for accurate construction. 13. Straight connectors for bottom side do not apply in this setup. 14. Board material needs to be 10 units thick. 15. Brace holes need to be three inches wide precisely. 16. The depth of braces' hole measures 20 units. 17. Notch's depth reaches exactly 30 units for structural stability.