My Customized mounting bracket modules for shelving system

thingiverse

Customized version of https://www.thingiverse.com/thing:725453 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=725453 Instructions Using the following settings: Board thickness is set to 7.5 mm. No straight connector will be attached at the bottom. The foot width has been set to 30 mm. Connectors are positioned at a 90-degree angle. The shell thickness is 2 mm. A hole for the board will be inserted. This design is for a top part, not a bottom one. The fillet radius for edges is 7 mm. The notch length is set to 35 mm. A hole for the brace will be included in the design. An offset of 16 mm from the ground has been applied. No back parts will be added to the design. Four connectors will be used in this custom version. The size of the holes for the brace is 3 mm. The depth of the holes for the brace is set to 20 mm. The size of the holes for the board is also 3 mm. The notch depth has been adjusted to 30 mm. The back part hole size is set to 3 mm.