My Customized MK8 Adjustable Fan Holder

thingiverse

Customized version of https://www.thingiverse.com/thing:1046948 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=1046948 Using the following settings: build_plate_manual_y is set to 200 build_plate_manual_x is set to 200 fan_holedist is 30 mm in length rail_width0 measures 6 mm in width duct_length is measured at 38 mm faceplate_hole_dist measures 31 mm in diameter rail_polar_2 measures 20 degrees from rail axis rail_polar_1 sets 0 degree for reference duct_angle is set to 45 degrees faceplate_base_depth measures 6 mm in height hinge_diam has a measurement of 8.0 mm in length duct_output_height is measured at 6.0 mm above plate duct_mount has hole type mounted hingeslide_block_holediam is 2.0 mm diameter fan_holediam has a hole measurement of 4.0 mm in diamater faceplate_hole_diam measures 4.0 mm in length rail_depth measures 2 mm below reference rail_offset sets an offset distance of 2 mm from rail axis show_build_plate is Yes faceplate_base_width measures 42 mm wide fan_width is set to 35 mm length hingeslide_dovelength is measured at 10 mm noz_yoffset has no effect on design settings hinge_nutdepth has measurement of 2.0 mm depth duct_output_diam measures 4.0 mm diameter push_hinge_to_edge is disabled, rail_length is set to 50 mm length build_plate_selector sets number 3 as preferred choice fan_clear adds a gap of .2 for space purposes hinge_nutwidth has measurement of 5.6 mm wide faceplate_base_height measures 10.0 mm height above plate surface hinge_clear_axial clears axis to measure .2 space rail_clear is cleared to allow for .4 more room hinge_holediam measures 4.0 in diamter