My Customized Mineral

thingiverse

Here are the customization settings I'm using for this custom version of the hexagone: - The minimum number of sides per polygon is set at four. - The top half of each petal will be clipped. - At least fifty percent of each petal must reach the base. - A tip will only start forming once the base of the flower reaches one twenty to one fifty percent height-wise. The parameters are as follows: * Number of sides for all hexagons, regardless of whether or not a seed is added to an inner polygon: Twenty four. * Size at which a petal will no longer grow in size after starting growth from an apex angle with a range from zero to ninety degrees, the latter when the base of a leaf meets this value and remains within the hexagon, forming one outer layer or 'ring' - thus the seed is located at the very center point - but only for layers two and onward. Ten. The apex itself will start rotating along its own plane by an angle whose starting range lies from zero to ninety degrees and rotates every twenty seconds if that value exceeds. No. Twenty-four hexagons with all of them centered over this ten unit value as specified above, so long as no more than seven petals reach or extend past it; at least fourteen have to be below this point for there not be at least one fully closed polygon - otherwise the model cannot continue to add polygons since every addition needs to always follow another hexagon with two of its six edges on an outer side, and both sharing an end point while they lie above their base's surface - excepting cases where this would cause self intersection by a third polygon already in progress towards completing all thirty four petals before even getting past sixteen, as long there still exists space available.