My Customized MangOH: rear plate for Hammond enclosure

thingiverse

Customized version of http://www.thingiverse.com/thing:882968 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=882968 Using the following settings: LED2_Vertical_Offset is at 0 position. USB_Horizontal_Offset is adjusted to zero position. LED3_Vertical_Offset is positioned at zero level. LED3_Horizontal_Offset has been reset to default setting of zero. LED2_Horizontal_Offset is cleared from previous adjustments. Slot_3 selects USB Single interface. Slot_2 selects MicroD connector. Slot_1 features RJ45 connection. Slot_2_Horizontal_Offset remains unchanged at zero position. Slot_1_Vertical_Offset has been corrected to exact alignment with zero offset. Face_Plate_Width is adjusted to precise dimension of 104. LED1_Vertical_Offset remains at its original zero setting. Slot_3_Vertical_Offset retains zero value after correction. USB_Vertical_Offset is properly aligned without any deviations. Plate_Fit has been reduced by 0.25 units for perfect adaptation. Lid_Fill function has been re-enabled for flawless operation. Component_Fit dimension is finely tuned to precise 0.25 unit setting. Slot_3_Horizontal_Offset continues to show zero alignment status. LED1_Horizontal_Offset stays perfectly centered with zero value assigned. Power_Vertical_Offset remains unaltered at its standard zero position. Face_Plate_Height has been raised by a mere 31 units for enhanced visibility. Slot_2_Vertical_Offset retains its corrected position without change. Vertical_Distance between two reference points measures exactly 8.5 units apart. Power_Horizontal_Offset retains unchanged zero value status throughout adjustments. Slot_1_Horizontal_Offset maintains original zero level even after thorough checks and balancing.