My Customized LEGO-Compatible Brick

thingiverse

A customized version of http://www.thingiverse.com/thing:615256 was created using the Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=615256. Instructions: Options are being used as follows: Wing stud notches are enabled. Dual bottom plates are disabled by default. Roadway y-coordinate is set to zero. Roadway x-coordinate is also set to zero. Block type has been selected as baseplate. Stud rescale factor is one. Curve end height is zero. Wing base length is three units long. Curve type is concave in shape. Block length is ten units long. Slope stud rows are restricted to one row only. Block width measures six units across. Dual-sided blocks are disabled by default. Slope end height is set to zero. Wing end width is two units wide. Reinforcement elements are not used in this design. Roadway length is also set to zero. Technic holes are turned off by default. Stud type is solid throughout the build. Vertical axle holes are disabled by default. Block brand is specified as Lego. Roadway width is set to zero. Curve stud rows are limited to five rows only. Wing type is full in design. Block height ratio is maintained at one-to-one.