My Customized LEGO-Compatible Brick

thingiverse

Instructions Using the following options: block_width is set to 2 Block height is calculated at one-third Wing base length is established as 3 units A single slope stud row is utilized Notches are enabled on wing studs The full type of wing is selected The block length has been designated as 14 units No additional elevation is added to the end of the slope Reinforcement is disabled for this build Lego is specified as the brand of block used The roadway y-coordinate is set at 0 units The roadway x-coordinate is also set to 0 units A solid stud type has been chosen with a scale factor of one This model does not use dual-sided blocks No vertical axle holes are present in this design There is no curved end elevation specified Curve stud rows have been determined as five units Wing end width is designated at two units