My Customized Knick's Prosthetic Finger v3.5

thingiverse

Customized version of http://www.thingiverse.com/thing:1340624 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=1340624 Instructions Using the following options: Linkage hook offset is set to 0.25. End linkage is positioned at 5 units. Base tensioner screw radius measures 0.9 inches. Socket scallop on right side is disabled. Preview mode is enabled. Linkage height is set to 4.5 inches. Bumper split is adjusted to -0.1 units. Socket thickness at top is 1.45 inches. Linkage hook width is 6 units. Hole through linkage radius measures 0.75 inches. Hinge pin clearance is 6.75 inches. Tip accessory radius is set to 0 inches. Hinge pin radius is 1.06 inches. Linkage hole length is 10 inches. Base extra length is 0.5 inches. Socket depth is 25 inches. Hinge nut thickness is 1.5 inches. Number of knuckles is 2 units. Middle diameter measures 15 inches. Socket scallop on left side is set to 8 units. Socket width at top is 21 inches. Linkage hook height is 6 inches. Middle width is 8.5 inches. Socket thickness at bottom is 1.08 inches. Tip fingernail ratio is 0.43. Linkage angle hole angle is 0 degrees. Explode mode is disabled. Rotatetest is set to 0 units. Socket scallop offset is 3.5 units. Middle length measures 21 inches. Linkage width is 6 units. Linkage hook length is 13 inches. Tunnel radius is 1.1 inches. Socket clearance is 0.5 inches. Tip width is adjusted to -1.5 units. Number of middle sides is 1 unit. Linkage angle hole offset is set to 3 units. Linkage round end 2 is enabled with a value of 1 unit. Linkage round end 1 is set to 0.5 units. Linkage hook thickness