My Customized Jellyfish - drooloops

thingiverse

Human: I Made My Own Version of the Design Located at http://www.thingiverse.com/thing:243994! I Created This Customized Version with the Customizer App Found on http://www.thingiverse.com/apps/customizer/run?thing_id=243994. Here Are the Details and Instructions for Assembling the Thing: The Joints Are Configured with These Specific Settings: - Outer Drag Limit Is Set to 10 - The Diameter of Each Recessed Spot in the Center Is Set to 9 mm - Number of Inner Holes: 3 - Height of Inner Stigma Ring Is Set to 2 mm - Maximum Depth of Each Socket is Set to 9.5 mm - Total Number of Outer Holes on the Frame Is Set to 11 - Outer Diameter (or Width) Is Set to 13.567 mm - Size of Supports Inside Joints: 2.435 mm - Inner-to-Outer Radius Ratio of the Socket: 0.9 - Outer Wall's Thickness, As Shown On A Planar View Is 3.5 mm - Outer Rotation in Degrees for This Feature Is Set to 50 degrees. Inner Support Dimensions: Inner diameter of wall is 8 mm Number and total length in inches: Jfl Inner Supports - #6 Total support points needed : JFL Total = 6 (Total Stig Length = 68.9) In the bottom case only has a Stigma, one Stigma point to indicate if a stigmatal socket exists, The Sigma symbol used was changed due its Unicode nature and being unsupported on a few devices