My Customized iPhone Stencil Case

thingiverse

Customized Version of http://www.thingiverse.com/thing:58001 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=58001 Using the Following Options: corner radius set to eight units index position for image set to zero index position for image two set to one perimeter tolerance on corners set to half a unit iphone version selected as two units corner radius on top surface set to four units length of product set to one hundred twenty-three point eight case type chosen as number one option pattern thickness measured at five units rotation angle for design calculated at thirteen degrees thinness factor set to point one oh oh zero units mashup selection option selected include hooks in the project not required material thickness measured at two point four units index position for top surface corners adjusted to eight units index position for bottom width corners fixed at fifty-eight point five-five design image rotation measured at thirty degrees overlap allowance on pattern set to eighteen units small-width measurement set at six point one units design pattern shape selected as six options main color designated as red small width measurement corrected to fifty-eight point six corner radius for bottom surface reduced to eight units taper rate on the case fixed at three points narrow-width adjustment corrected to six point seventeen vertical shift off-set zero units set as zero value horizontal shift off-set zero units measured zero tolerance value four height lowered to point two zero units design height selected as seven point six radius setting on pattern adjusted up eighteen points image scaled up by one hundred percent mark lower corner measurement fixed at one hundred fifteen point twenty-five small-height dimension locked in place at nine point five top surface width rechecked against forty-nine units Note: To produce or edit designs with these settings visit the original site http://www.thingiverse.com