My Customized iPhone 4,5,6 Stencil Case

thingiverse

Human: Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=813330 Instructions Using the following settings: - Width is set to 67 units. - The outer radius of each corner is 8 units. - Each section width for mashups is 6.1 units. - Swidth for sections without mesh is also 6.1 units. - Mashup type chosen is 1. - The height for the inner corners is set at 9.5 units. - Overlap in pattern repetition is at 14 units. - Case taper is done in a circular fashion, at an angle of 3. - The primary color selected is red. - The height tolerance for the mesh sections is .2 units high. - The pattern rotation is set at 17 degrees. - The outer width chosen is 58.55 units. - Perimeter tolerance on inner edges is .5 units wide. - Pattern radius is defined as 16 units wide. - Each mashup is given a thickness of 6 units deep. - Index value for the current mashup section is set to 0. - Same index setting applied to inner case dimensions, also 0. - Section thickness on mesh parts comes in at .8 inches. - Length of each outer piece comes out to be 138 units. - Outer dimensions have been optimized without hooks, that's a choice I've made. - The length within the outer border for sections is around 115.25 units. - Radius for inner corners set back up again, now at 8 units. - Swidth on these inner areas measured to 6.17 inches each. - Mashups come in .5 units below outer edge perimeters in dimensions and specifications. - Thickness added to these mashup sections was reduced slightly to 1.0 units. - A second option has been eliminated since no image or icon can be embedded directly on this build, at 0 units for Y position. - And just to cover my back, an off-center offset in the X axis, still remains steady at a total of 0 units wide by way of final dimension control in our case's development, if not necessary then it was always at its current default. - Another key variable controlled on design side: this build now includes all applicable specifications for what is best defined by the parameters found within and specified through our tool for creation, so an image is indeed scaled with value 111 assigned - we also included that particular information as it should naturally be incorporated directly into case's overall build strategy moving forward. - Case taper was chosen in this custom build with all other specifics now accounted for according to given specifications at design phase start: corner radius defined and selected per specific user preference is back up at eight once more as a last but still significant setting value to check. - Another setting we reviewed during our analysis, which included mesh case shape set back on standard form that we also considered, was that chosen for use of color within custom build of an object, selected by the client from available options, in this particular instance set at red once more, a well-established popular color that fits with overall user's desires moving forward. - We are confident now with review finished here in conclusion regarding these specifications used directly in process for developing said 3D model: each relevant piece falls into correct position as established through all available custom options - and to finally put last touches on, case material thickness is chosen per our discussion and review here today and confirmed at the level of one point eight units as the selected dimension control option we implemented according to client's precise wishes, also fitting exactly as requested in specifications list.