My Customized Improved Phone Case

thingiverse

Instructions to Build a Custom Phone Case Using the following options: - Increase the stencil pattern element overlap by setting it to -10. - Adjust custom right port length to be shorter, 25 mm long instead of 30 mm. - Thicken the custom bottom port corner radius, increasing its size by 2 units. - Make custom back camera x size larger than normal by setting it at 22 units. - Fine-tune custom left port corner resolution with an increased value, making it a full number at 9 units instead of fractional. - Use standard dimensions, disabling the customized ones with a 0 flag. - Position custom back extra port y position closer to bottom of phone, positioning at 25 mm above the lower edge of the phone case instead of 30 mm. - Lower case thickness with a decrease by .5 mm. - Set stencil shape to square. - Adjust horizontal placement of stencil further from edge of phone case with -15 units. - Fine-tune custom top port corner resolution up slightly, setting it higher at full number value 9 instead of fraction 8. - Decrease width of phone, cutting back length to standard by setting size to a smaller 80 mm for the case dimensions. - Position extra back port x position on the right edge by moving placement -10 mm away from right-hand side edge and towards back face, not affecting camera hole positioning as this remains central still; - Move custom top outer edge chamfer radius to -20 mm which moves this radius further outward along case exterior and increases thickness of rounded edges found in both corners (where inner surface meets outer) slightly, adjusting look to better show design's overall lines more effectively throughout phone when built out whole again after finishing any cuts needed inside too! Increase size up slightly now that one aspect already increased previously within given space remaining open still below maximum recommended by this design guideline overall goal: Increase total dimensions including wall thickness also –